Adjust The Input Color - Konica Minolta bizhub PRESS C6000 User Manual

10.3

Adjust the Input Color

10.3 Adjust the Input Color
This section describes how to adjust the selected original color (input color) and how to adjust the added
input color.
When you don't need to adjust the selected input color or added input color, go to the step described on
page 10-9.
The current setting can be stored for the selected input color. When you want to create the new setting on
base of the selected setting, make the duplication of it and adjust the duplication. For details on how to copy
the alternative color setting and how to delete it, refer to page 10-13.
1
When you select [CMYK] tab and select the input color, check [Show Device Value].
% When you check, you can specify the input color with the device value (from "0 " to "255"; 256
steps).
% When you remove the check, you can specify the color with %.
2
Specify the RGB/CMYK values which are set in the input color to the input boxes under [Adjust] - [Orig-
inal].
According to the settings, the preview area of [Adjust] - [Original] and [Original] on the list are updated.
% When you select [RGB] tab, specify the value from "0" to "255" for each color.
% When you select [CMYK] tab and check [Show Device Value], specify the value from "0" to "255"
for each color.
% When you select [CMYK] tab and remove the check of [Show Device Value], specify the value from
"0" to "100" for each color.
% When you input below the decimal point, the value rounded down is displayed.
% Similar operation can be done when you change the RGB/CMYK values on the right of [Original] of
the list.
3
Confirm the preview of [Original], and repeat from Step 1 to Step 2 as required.
% When you adjust the output color to alternate, go to the step described on page 10-9.
IC-601
10
10-8