Replacing An Nvs Card - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010 Hardware Manual

Replacing an NVS Card

Copyright © 2010, Juniper Networks, Inc.
Remove the redundant SRP module from the chassis.
3.
Replace the NVS card on this SRP module. (See "Replacing an NVS Card" on page 81.)
4.
Reinsert the SRP module into the chassis.
5.
When this SRP module is available, synchronize the SRP modules.
6.
host1#synchronize
When the SRP modules are synchronized, reboot the SRP module that you upgraded.
7.
host1#reload slot 7
When this SRP module is available, synchronize the SRP modules.
8.
host1#synchronize
When the SRP modules are synchronized, force the redundant SRP module to take
9.
over from the primary SRP module.
host1#srp switch
Halt the redundant (former primary) SRP module.
10.
host1#halt standby-srp
Immediately remove the former primary SRP module.
11.
Repeat Steps 4–8 for the former primary SRP module.
12.
To replace an NVS card on an SRP module:
CAUTION: Before you insert or remove an NVS card from a running SRP
module, we strongly recommend that you halt the SRP module or shut down
the router. Failure to do this can result in file corruption in one or both cards.
See JunosE System Basics Configuration Guide, Chapter 6, Managing Modules
for information about the halt command.
Obtain an antistatic container for the NVS card you plan to remove. (See "Storing
1.
Modules and Components" on page 78.)
Be sure you have halted the SRP module using the halt command.
2.
With a small flathead screwdriver, remove the faceplate from the NVS card slot on
3.
the SRP module. (See Figure 37 on page 82.)
Use the screwdriver to depress the release button next to the NVS card. (See Figure
4.
37 on page 82.)
This action releases the NVS card.
Chapter 8: Maintaining ERX Routers
81