Replacing An Nvs Card - Juniper E Series Hardware Manual

9.
10.
11.
12.

Replacing an NVS Card

To replace an NVS card on an SRP module:
1.
2.
3.
Figure 40: NVS Card Slot on SRP Module
4.
host1#synchronize
When the SRP modules are synchronized, force the redundant SRP module to
take over from the primary SRP module.
host1#srp switch
Halt the redundant (former primary) SRP module.
host1#halt standby-srp
Immediately remove the former primary SRP module.
Repeat Steps 4–8 for the former primary SRP module.
Obtain an antistatic container for the NVS card you will remove (see "Storing
Modules and Components" on page 82).
With a small flathead screwdriver, remove the faceplate from the NVS card slot
on the SRP module (see Figure 40).
Use the screwdriver to depress the button next to the NVS card (see Figure 40).
This action releases the NVS card.
NVS card
Faceplate
Remove the NVS card and place it in the antistatic container.
Release button
Upgrading NVS Cards on SRP Modules
Maintaining E-series Routers
85