Assigning An Ip Address - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010 Hardware Manual

Assigning an IP Address

Copyright © 2010, Juniper Networks, Inc.
Connect the female DB-9 connector to the RS-232 port on the system's SRP I/O
1.
module. See Figure 36 on page 71.
Figure 36: Management Ports for ERX Routers
ERX310 router
ERX7xx models
Connect the crossover adapter connector to your PC's serial port.
2.
Power up the system.
3.
When you power up the system, the CLI appears on your console's screen. The system
is now in User Exec mode, and you can begin configuration. For more information on
using the CLI and configuring the system, see the JunosE System Basics Configuration
Guide.
NOTE: Direct access through the RS-232 serial port enables you to monitor
the system while it boots.
When your console is ready to communicate with the system, power up the system. (See
"Powering Up ERX Routers" on page 65.) Then set an IP address for the system. The
system powers up in User Exec mode. To assign an IP address:
Enter the enable command at the User Exec prompt.
1.
host1>enable
host1#
The system is now in Privileged Exec mode.
Set an IP address on the Ethernet interface:
2.
Chapter 7: Accessing ERX Routers
ERX14xx models
71