Replacing An Nvs Card - Juniper ERX-1410 Installation And User Manual

7-4 CHAPTER 7
Maintaining the ERX System

Replacing an NVS Card

6
When this SRP module is available, synchronize the SRP modules.
host1#synchronize
7
When the SRP modules are synchronized, reboot the SRP module
that you upgraded.
host1#reload slot 6
8
When this SRP module is available, synchronize the SRP modules.
host1#synchronize
9
When the SRP modules are synchronized, force the redundant SRP
module to take over from the primary SRP module.
host1#srp switch
10
Immediately remove the former primary SRP module.
11
Repeat steps 4–8
To replace an NVS card on an SRP module:
1
Obtain an antistatic container for the NVS card you will remove (see
Storing Modules and
2
With a small flathead screwdriver, remove the faceplate from the
NVS card slot on the SRP module (see
3
Use the screwdriver to depress the button next to the NVS card (see
Figure 7-1).
This action releases the NVS card.
for the former primary SRP module.
Components, earlier in this chapter).
Figure 7-1).