CHAPTER 4
Installing Modules
Overview
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to install and remove E Series modules. For information about
managing installed modules, see JunosE System Basics Configuration Guide, Chapter 6,
Managing Modules.
This chapter contains the following sections:
Line module slots are located in the front of each ERX chassis, while I/O module slots
are located in the rear. See "ERX Overview" on page 3 for front and rear views of ERX
routers.
In ERX14xx models, modules mount vertically in a chassis with 14 slots. In ERX7xx models
and ERX310 Broadband Services Routers, modules mount horizontally in a chassis with
7 slots and 3 slots, respectively. See Figure 16 on page 32.
31