Configuring Line Module Redundancy; The Next Step - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010 Hardware Manual

ERX 11.3.x Hardware Guide

Configuring Line Module Redundancy

The Next Step

46
The system reboots.
Issue the show redundancy command, and verify that the display shows the
2.
redundancy hardware.
For information about configuring line module redundancy, see JunosE System Basics
Configuration Guide, Chapter 6, Managing Modules.
After you install the modules, you can connect cables to the system. See "Cabling ERX
Routers" on page 47.
Copyright © 2010, Juniper Networks, Inc.