ERX 11.3.x Hardware Guide
Installing SFPs
86
Different SFPs use different release mechanisms. (See Figure 40 on page 86.) Possible
release mechanisms include:
A button that you press inward
A ring that you press inward
A bar that you pull sideways, then outward
A tab that you pull sideways, then outward
Figure 40: Possible Release Mechanisms on the SFP
Release the SFP and pull it out of the slot.
5.
Place the SFP in an antistatic bag.
6.
If you are using the redundant port on the GE I/O module, repeat Steps 3–6 for the
7.
other SFP.
CAUTION: For port redundancy to operate correctly, both the primary and
redundant ports on a GE I/O module must use the same type of SFP.
To install SFPs:
Put the antistatic wrist strap on your wrist, and connect the strap to the ESD grounding
1.
jack on your system.
Identify the following items on the SFP, as shown in Figure 41 on page 87:
2.
The connection circuitry on the base
The cable connectors on the front
The cable connectors are protected by a dust cover.
Copyright © 2010, Juniper Networks, Inc.