ERX 11.3.x Hardware Guide
Regulatory Compliances
Safety Guidelines
118
Choose a location for the router that is dry, relatively dust free, well ventilated, and air
conditioned. If you install equipment in a rack, be sure that the floor is capable of
supporting the combined weight of the rack and the installed equipment. Place the router
in a location with sufficient access to power and network cables.
Like other network devices, the router generates a significant amount of heat. You must
provide a balanced environment so that the router performs properly and safely. See
"System Specifications" on page 109 for acceptable ranges of temperature and humidity.
Be sure to allow enough space around the router for adequate ventilation. Inadequate
ventilation can cause the system to overheat.
CAUTION: Do not block the air vents on the routers. Otherwise, the router
might overheat.
See "System Specifications" on page 109, for a complete list of regulatory compliance
requirements, including safety, EMC, and telecommunications.
For your safety, before installing the system, review all safety warnings in this section.
WARNING: The recommended maximum ambient temperature is 50° C
(122° F). For safe operation, take into consideration the internal temperature
of the rack.
WARNING: Install equipment in the rack from the bottom upward. Doing this
helps maintain the stability of the rack and reduces the chance of the rack
tipping over.
WARNING: Do not insert any metal object, such as a screwdriver, into an
open slot or the backplane. Doing so might cause electric shock and serious
burns.
WARNING: Three people are required to install the router in a rack: two to
lift the system into position and one to screw it to the rack.
Copyright © 2010, Juniper Networks, Inc.