The Next Step - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010 Hardware Manual

The Next Step

Copyright © 2010, Juniper Networks, Inc.
A No. 2 Phillips screwdriver
Depending on the router, up to eight 10-32 x 3/8 Phillips screws (provided with the
router) for each router to be installed
WARNING: Three people are required to install the router in a rack: two to
lift the system into position and one to screw it to the rack.
CAUTION: Make sure all persons handling a router wear an antistatic device.
To install the router in the rack:
With one person standing on the left side of the router and another standing on the
1.
right side, lift the router into the rack.
Position the router in its designated location in the equipment rack. Make sure the
2.
holes of the mounting brackets align evenly with the holes of the equipment rack on
both sides.
Starting at the bottom, have the third person secure the router in the equipment rack
3.
by using the 10-32 x 3/8 Phillips screws.
Connect the necessary cables. (See "Cabling ERX Routers" on page 47 for instructions
4.
on installing the cables.)
Figure 15 on page 27 illustrates a distribution rack with one ERX310 router, one ERX7xx
model, and one ERX14xx model installed.
After you finish installing the router:
If you need to install any modules, see "Installing Modules" on page 31.
If the router was delivered with the modules already installed, see "Cabling ERX Routers"
on page 47 for instructions on connecting cables.
Chapter 3: Installing ERX Routers
29