Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010 Hardware Manual page 100

ERX 11.3.x Hardware Guide
84
Locate the four SODIMM sockets on the SRP module. (See Figure 38 on page 84 and
1.
Figure 39 on page 84.) See the previous section to learn how to remove SODIMMs.
Figure 38: SODIMM Sockets on the SRP-5 and SRP-10 Module
Figure 39: SODIMM Sockets on the SRP-40 Module
Insert a SODIMM from the upgrade kit at an angle of approximately 45 degrees into
2.
an empty ceramic connector, so that the notch in the long gold edge of the SODIMM
aligns with the notch in the connector.
The notch on the long gold edge is no longer visible when the SODIMM is pressed in
far enough.
Press the top surface downward into the socket until the socket spring snaps into
3.
place and holds it.
Repeat Steps 2–3 with the other SODIMM.
4.
Repeat Steps 1–4 for the other SRP module, if present.
5.
Copyright © 2010, Juniper Networks, Inc.