Table of Contents
Advertisement
to be sent as multicasts or remotely control a machine on that network segment
to act as the sender of these requests.
Users of SUSE Linux Enterprise Server 9 and higher can use a YaST module called
WOL to easily configure Wake on LAN. Users of other versions of SUSE Linux-based
operating systems can use a command line tool.
4.3.8 Wake on LAN with YaST
1 Log in as root.
2 Start YaST > Network Services > WOL.
3 Click Add and enter the hostname and MAC address of the target system.
4 To turn on this machine, select the appropriate entry and click Wake up.
4.3.9 Manual Wake on LAN
1 Log in as root.
2 Start YaST > Software Management and install the package netdiag.
3 Open a terminal and enter the following command as root to wake the target:
4.4 Booting the Target System for
Basically, there are two different ways to customize the boot process for installation
apart from those mentioned under
tion 4.3.3, "Using PXE Boot"
68
Deployment Guide
ether-wake
mac_of_target
Replace mac_of_target with the actual MAC address of the target.
Installation
Section 4.3.7, "Wake on LAN"
(page 62). You can either use the default boot options
(page 67) and
Sec-
Advertisement
Table of Contents
Troubleshooting
