Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 416

Do not set these links manually. If something is wrong in the INFO block, problems
will arise when insserv is run later for some other service. The manually-added
service will be removed with the next run of insserv for this script.
17.2.3 Configuring System Services
(Runlevel) with YaST
After starting this YaST module with YaST > System > System Services (Runlevel), it
displays an overview listing all the available services and the current status of each
service (disabled or enabled). Decide whether to use the module in Simple Mode or in
Expert Mode. The default Simple Mode should be sufficient for most purposes. The left
column shows the name of the service, the center column indicates its current status,
and the right column gives a short description. For the selected service, a more detailed
description is provided in the lower part of the window. To enable a service, select it
in the table then select Enable. The same steps apply to disable a service.
Figure 17.1 System Services (Runlevel)
For detailed control over the runlevels in which a service is started or stopped or to
change the default runlevel, first select Expert Mode. The current default runlevel or
"initdefault" (the runlevel into which the system boots by default) is displayed at the
400 Deployment Guide