Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 159

8.4.13 Sound
Most sound cards are detected automatically and configured with reasonable values
during initial installation. To install a card added later or modify settings, use Hardware
> Sound. It is also possible to switch the sequence of the cards.
Figure 8.5 Sound Configuration
If YaST cannot detect your sound card automatically, proceed as follows:
1 Click Add to open a dialog in which to select a sound card vendor and model.
Refer to your sound card documentation for the information required. Find a
reference list of sound cards supported by ALSA with their corresponding sound
modules in /usr/share/doc/packages/alsa/cards.txt and at
http://www.alsa-project.org/alsa-doc/. After making your se-
lection, click Next.
2 In Sound Card Configuration, choose the configuration level in the first setup
screen:
Quick automatic setup
You are not required to go through any of the further configuration steps
and no sound test is performed. The sound card is configured automatically.
System Configuration with YaST 143