Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 212

1 Insert the SUSE Linux Enterprise SP CD 1 or DVD 1 and boot your machine.
2 Select Installation to boot the SP kernel from CD, then use F3 to enable Further
3 Provide the appropriate path information or select SLP as the installation source.
4 Select the appropriate installation server from those offered or use the boot options
Network Installation—PXE Boot
To perform a network installation of a SUSE Linux Enterprise Service Pack via network,
proceed as follows:
1 Adjust the setup of your DHCP server to provide the address information needed
2 Set up a TFTP server to hold the boot image needed for PXE boot.
3 Prepare PXE boot and Wake-on-LAN on the target machine.
4 Initiate the boot of the target system and use VNC to remotely connect to the
5 Accept the license agreement then select a language, default desktop, and other
196 Deployment Guide
A boot screen similar to the original installation of SUSE Linux Enterprise 10
is displayed.
Options, and finally F4 to select a type of network installation source (FTP,
HTTP, NFS, or SMB).
prompt to provide the type of installation source and its actual location as in
Section 3.1.4, "Installing from a Network Source without SLP"
starts.
Finish the installation as outlined in
for PXE boot according to
Boot" (page 67).
Use the first CD or DVD of your SUSE Linux Enterprise Service Pack for this
and otherwise follow the instructions in
Server" (page 60).
installation routine running on this machine. See
(page 73) for more information.
installation settings.
Chapter 3, Installation with YaST
Section 4.3.5, "Preparing the Target System for PXE
Section 4.3.2, "Setting Up a TFTP
Section 4.5.1, "VNC Installation"
(page 19). YaST
(page 17).