Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 781

Using YaST System Services (Runlevel)
Disable or enable AppArmor by removing or adding its boot script to the sequence
of scripts executed on system boot. Status changes are applied at the next system
boot.
Using Novell AppArmor Control Panel
Toggle the status of Novell AppArmor in a running system by switching it off or
on using the YaST Novell AppArmor Control Panel. Changes made here are applied
instantaneously. The Control Panel triggers a stop or start event for AppArmor and
removes or adds its boot script in the system's boot sequence.
To disable AppArmor permanently by removing it from the sequence of scripts executed
on system boot, proceed as follows:
1 Log in as root and start YaST.
2 Select System > System Services (Runlevel).
3 Select Expert Mode.
4 Select boot.apparmor and click Set/Reset > Disable the service.
5 Exit the YaST Runlevel tool with Finish.
AppArmor will not be initialized on the next system boot and stays inactive until you
explicitly reenable it. Reenabling a service using the YaST Runlevel tool is similar to
disabling it.
Toggle the status of AppArmor in a running system by using the AppArmor Control
Panel. These changes take effect as soon as you apply them and survive a reboot of the
system. To toggle AppArmor's status, proceed as follows:
1 Log in as root and start YaST.
2 Select Novell AppArmor > AppArmor Control Panel.
3 Select Enable AppArmor. To disable AppArmor, uncheck this option.
4 Exit the AppArmor Control Panel with Done.
Confining Privileges with AppArmor 765