Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 711

in as user root. If you do not have a special Samba root account, use the system root
account.
NOTE: Activating SWAT
After Samba server installation, SWAT is not activated. To activate it, open
Network Services > Network Services (xinetd) in YaST, enable the network services
configuration, select swat from the table, and click Toggle Status (On or Off).
36.3.3 Configuring the Server Manually
If you intend to use Samba as a server, install samba. The main configuration file of
Samba is /etc/samba/smb.conf. This file can be divided into two logical parts.
The [global] section contains the central and global settings. The [share] sections
contain the individual file and printer shares. By means of this approach, details regarding
the shares can be set differently or globally in the [global] section, which enhances
the structural transparency of the configuration file.
The global Section
The following parameters of the [global] section need some adjustment to match
the requirements of your network setup so other machines can access your Samba
server via SMB in a Windows environment.
workgroup = TUX-NET
This line assigns the Samba server to a workgroup. Replace TUX-NET with an
appropriate workgroup of your networking environment. Your Samba server appears
under its DNS name unless this name has been assigned to any other machine in
the network. If the DNS name is not available, set the server name using
netbiosname=MYNAME. See mansmb.conf for more details about this param-
eter.
os level = 2
This parameter triggers whether your Samba server tries to become LMB (local
master browser) for its workgroup. Choose a very low value to spare the existing
Windows network from any disturbances caused by a misconfigured Samba server.
More information about this important topic can be found in the files
Samba 695