Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 544

5 For each user, specify whether to grant switch permissions only or whether this
6 Click Finish to apply your settings and close YaST.
Figure 27.2 YaST: Configure SCPM Users
27.3.3 Creating a New Profile
After you have enabled SCPM, you have a profile named default that contains your
current system configuration. Create another profile that matches the requirements of
the other setup.
To add a new profile based on the current system configuration, proceed as follows:
1 Right-click the Profile Chooser and select Run Profile Manager (SUMF).
2 Select Profiles > Add.
3 Enter the name of the new profile and click OK.
4 Determine whether the new profile should be the active profile.
528 Deployment Guide
user should be allowed to switch, modify, and create profiles.