Table of Contents
Advertisement
option is automatically activated in accordance with the selected resolution and the
graphics card. There are three ways to disable the SUSE screen, if desired:
Disabling the SUSE Screen When Necessary
Enter the command echo 0 >/proc/splash on the command line to disable
the graphical screen. To activate it again, enter echo 1 >/proc/splash.
Disabling the SUSE screen by default.
Add the kernel parameter splash=0 to your boot loader configuration.
The Boot Loader
prefer the text mode, which was the default in earlier versions, set vga=normal.
Completely Disabling the SUSE Screen
Compile a new kernel and disable the option Use splash screen instead of boot logo
in framebuffer support.
TIP
Disabling framebuffer support in the kernel automatically disables the
splash screen as well. SUSE cannot provide any support for your system if
you run it with a custom kernel.
18.7 Troubleshooting
This section lists some of the problems frequently encountered when booting with
GRUB and a short description of possible solutions. Some of the problems are covered
in articles in the Knowledge base at http://support.novell.com/. Use the
search dialog to search for keywords like GRUB, boot, and boot loader.
GRUB and XFS
XFS leaves no room for stage1 in the partition boot block. Therefore, do not
specify an XFS partition as the location of the boot loader. This problem can be
solved by creating a separate boot partition that is not formatted with XFS.
GRUB Reports GRUB Geom Error
GRUB checks the geometry of connected hard disks when the system is booted.
Sometimes, the BIOS returns inconsistent information and GRUB reports a GRUB
Geom Error. If this is the case, use LILO or update the BIOS. Detailed information
422
Deployment Guide
(page 405) provides more information about this. However, if you
Chapter 18,
Advertisement
Table of Contents
Troubleshooting
