Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 625

6over4
IPv6 packets are automatically encapsulated as IPv4 packets and sent over an IPv4
network capable of multicasting. IPv6 is tricked into seeing the whole network
(Internet) as a huge local area network (LAN). This makes it possible to determine
the receiving end of the IPv4 tunnel automatically. However, this method does not
scale very well and is also hampered by the fact that IP multicasting is far from
widespread on the Internet. Therefore, it only provides a solution for smaller cor-
porate or institutional networks where multicasting can be enabled. The specifica-
tions for this method are laid down in RFC 2529.
6to4
With this method, IPv4 addresses are automatically generated from IPv6 addresses,
enabling isolated IPv6 hosts to communicate over an IPv4 network. However, a
number of problems have been reported regarding the communication between
those isolated IPv6 hosts and the Internet. The method is described in RFC 3056.
IPv6 Tunnel Broker
This method relies on special servers that provide dedicated tunnels for IPv6 hosts.
It is described in RFC 3053.
30.2.4 Configuring IPv6
To configure IPv6, you do not normally need to make any changes on the individual
workstations. IPv6 is enabled by default. You can disable it during installation in the
network configuration step described in
(page 32). To disable or enable IPv6 on an installed system, use YaST Network Card.
Do not change the method and click Next. Then select a card and click Advanced >
IPv6 in the Address tab. To enable IPv6 manually, enter modprobe ipv6 as root.
Because of the autoconfiguration concept of IPv6, the network card is assigned an ad-
dress in the link-local network. Normally, no routing table management takes place on
a workstation. The network routers can be queried by the workstation, using the router
advertisement protocol, for what prefix and gateways should be implemented. The
radvd program can be used to set up an IPv6 router. This program informs the worksta-
tions which prefix to use for the IPv6 addresses and which routers. Alternatively, use
zebra for automatic configuration of both addresses and routing.
Consult the ifup(8) man page to get information about how to set up various types of
tunnels using the /etc/sysconfig/network files.
Section 3.11.3, "Network Configuration"
Basic Networking 609