Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 623

Table of Contents

Advertisement

::1 (loopback)
The address of the loopback device.
IPv4 Compatible Addresses
The IPv6 address is formed by the IPv4 address and a prefix consisting of 96 zero
bits. This type of compatibility address is used for tunneling (see
"Coexistence of IPv4 and IPv6"
municate with others operating in a pure IPv4 environment.
IPv4 Addresses Mapped to IPv6
This type of address specifies a pure IPv4 address in IPv6 notation.
Local Addresses
There are two address types for local use:
link-local
This type of address can only be used in the local subnetwork. Packets with a
source or target address of this type should not be routed to the Internet or
other subnetworks. These addresses contain a special prefix (fe80::/10)
and the interface ID of the network card, with the middle part consisting of
zero bytes. Addresses of this type are used during automatic configuration to
communicate with other hosts belonging to the same subnetwork.
site-local
Packets with this type of address may be routed to other subnetworks, but not
to the wider Internet—they must remain inside the organization's own network.
Such addresses are used for intranets and are an equivalent of the private address
space defined by IPv4. They contain a special prefix (fec0::/10), the inter-
face ID, and a 16 bit field specifying the subnetwork ID. Again, the rest is
filled with zero bytes.
As a completely new feature introduced with IPv6, each network interface normally
gets several IP addresses, with the advantage that several networks can be accessed
through the same interface. One of these networks can be configured completely auto-
matically using the MAC and a known prefix with the result that all hosts on the local
network can be reached as soon as IPv6 is enabled (using the link-local address). With
the MAC forming part of it, any IP address used in the world is unique. The only variable
parts of the address are those specifying the site topology and the public topology, de-
pending on the actual network in which the host is currently operating.
(page 608)) to allow IPv4 and IPv6 hosts to com-
Section 30.2.3,
Basic Networking
607

Advertisement

Table of Contents
loading

This manual is also suitable for:

Linux enterprise desktop 10 sp2

Table of Contents