Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 543

5 Set the boot mode and determine whether changes to the current profile should
be saved or discarded with profile switching triggered at boot time.
6 Make sure that all resource groups needed are covered by the active selection,
displayed in the Resource Groups section. If you need additional resource groups,
adjust the resources with Configure Resources. For details, refer to
"Configuring Resource Groups"
For the example scenario, you do not need to configure additional resources,
because printer and network resources are included by default.
Figure 27.1 YaST: Basic SCPM Configuration
To allow users other than root to manage profiles, proceed as follows:
1 Start YaST from the main menu and select the YaST Profile Manager.
2 Check Permit non-root Users to Manage Profiles. See
Configure SCPM Users"
3 Click Configure.
4 Click Add to add any user who should be able to manage profiles.
(page 530).
(page 528).
System Configuration Profile Management
Section 27.3.6,
Figure 27.2, "YaST:
527