Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 218

4 In the restarted Software Updater, page down and select the optional
5 In the Software Updater apply the product-sled10-sp2 and
6 Click Close to finish the update to SUSE Linux Enterprise 10 SP2 and reboot.
Using rug
For background information about rug command line tool, see
from the Command Line with rug"
for the update.
Before initiating the online update using rug to progress to the SP feature level, make
sure that the requirements are met as listed in
date"
This it the minimal command sequence needed to migrate the system to the SP2 patch
level:
rug up -t patch -g security && rug ping -a
# the following command will also install slesp1u-libzypp
rug up -t patch -g recommended && rug ping -a
rug in -t patch move-to-sled10-sp2 && rug ping -a
rug refresh
rug up -t patch -g recommended && rug ping -a
reboot
NOTE
rug ping -a ensures, that the ZMD initialization is complete after the previ-
ous rug command.
202 Deployment Guide
move-to-sled10-sp2 patch and apply it. If you do not select it, your system
will stay at the SP1 feature level and you will get bug fixes and security updates
only for a limited time (six month after the availibility of SP2).
slesp2o-sp2_online patch to bring the system to the SP2 level. Both these
patches are mandatory, if you installed move-to-sled10-sp2 during the
steps before, and therefore are preselected.
(page 198).
(page 179). Use rug, if you need a scriptable solution
Section "Starting with YaST Online Up-
Section 8.14, "Update