Novell LINUX ENTERPRISE DESKTOP 10 SP2 - DEPLOYMENT GUIDE 08-05-2008 Deployment Manual page 199

8.15.1 Card and Monitor Properties
Adjust the settings for your graphics card and display device in Card and Monitor
Properties. If you have more than one graphics card installed, each device is shown in
a separate dialog reachable by a tab. At the top of the dialog, see the current settings
for the selected graphics card and the monitor that is attached to it. If more than one
screen can be connected to the card (dual head), the monitor on the primary output is
shown. Normally, the card and display device are detected automatically by the system
during installation. However, you can tune many parameters manually or even change
the display device completely.
Figure 8.11 Card and Monitor Properties
TIP: Autodetecting New Display Hardware
If you change your display hardware after installation, use sax2 -r on the
command line to cause SaX2 to detect your hardware. You must be root to
run SaX2 from the command line.
System Configuration with YaST 183