Configure Automatic Support Bundle Collection; Create Disk Group - Dell PowerVault MD3260 Cli Manual

Syntax
clear (allVirtualDisks | virtualDisk
[virtualDiskName] | virtualDisks [virtualDiskName1
... virtualDiskNameN]) unreadableSectors
Parameters
Parameter
allVirtualDisks
virtualDisk or virtualDisks
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >) to overcome this limitation.

Configure Automatic Support Bundle Collection

This command enables or disables the automatic collection of support bundles on one or more storage arrays when a
critical MEL event is detected.
NOTE: This command must be run from the command line. It cannot be run in the MD Storage Manager script
editor.
Syntax
supportBundle auto (enable|disable) (all | storageArrayName) [data=pathName]
Parameters
Parameter
enable
disable
all
storageArrayName
data

Create Disk Group

This command creates either a free-capacity disk group or a disk group with one virtual disk when you enter a set of
assigned physical disks.
Description
Clears unreadable sector information from all of the virtual disks in the
storage array.
The name of the specific virtual disk for which you want to clear
unreadable sector information. You can enter more than one virtual disk
name. Enclose the virtual disk name in square brackets ([ ]). If the virtual
disk name has special characters, you also must enclose the virtual disk
name in double quotation marks (" ").
Description
Enable automatic collection of support bundles when a
critical MEL event is detected.
Disable automatic collection of support bundles where the
feature was previously enabled.
Apply the command to all storage arrays detected from
the host.
Apply the command to the named storage array.
Store the data generated by the command at the location
specified by the
pathName .
105