Deactivate Remote Replication; Delete Disk Group - Dell PowerVault MD3260 Cli Manual

Parameter
copyPriority
targetReadOnlyEnabled
copyType

Deactivate Remote Replication

NOTE: This command valid only with Fibre Channel storage arrays.
This command deactivates the Remote Replication premium feature, disassembles the replication repository virtual disk,
and releases the RAID controller module owner of the secondary virtual disk. The RAID controller module host port that
is dedicated to the secondary virtual disk is available for host data transfers.
Syntax
deactivate storageArray feature=remoteReplication
Parameters
None.

Delete Disk Group

This command deletes an entire disk group and its associated virtual disks.
130
Description
NOTE: You can use any combination of alphanumeric
characters, hyphens, and underscores for the names.
Command names can have a maximum of 30
characters. If you exceed the maximum character
limit, replace square brackets ([ ]) with angle brackets
(< >) to overcome this limitation.
Specifies the priority that a virtual disk copy has relative to
host I/O activity. Valid entries are highest, high, medium,
low, or lowest.
NOTE: CopyPriority defines the amount of system
resources used to copy the data between the source
virtual disk and target virtual disk of a virtual disk-
copy pair. If you select the highest priority level, the
virtual disk copy uses the most system resources to
perform virtual disk copy, which decreases
performance for host data transfers.
Specifies whether the target virtual disk is write enabled
or read only. To be able to write to the target virtual disk,
set this parameter to FALSE. To prevent writing to the
target virtual disk, set this parameter to TRUE.
Creates a virtual disk copy with or a snapshot. Creating a
virtual disk copy with a snapshot enables you to continue
to write to the source virtual disk while creating the virtual
disk copy. To create a virtual disk copy with a snapshot,
set this parameter to online. To create a virtual disk copy
without a snapshot, set this parameter to offline.
If this parameter is not used, the virtual disk copy is
created without a snapshot.