NOTE: Use the show controller NVSRAM command to display parts or all of the NVSRAM before using the
set controller command to change NVSRAM values.
Show Remote Replication Virtual Disk Candidates
NOTE: This command valid only with Fibre Channel storage arrays.
This command returns information about the candidate virtual disks on a remote storage array that can be used as
secondary virtual disks in a Remote Replication configuration.
Syntax
show remoteReplication candidates primary= "virtualDiskName"
remoteStorageArrayName=storageArrayName
Parameters
Parameter
primary
remoteStorageArrayName
Show Remote Replication Virtual Disk Synchronization Progress
NOTE: This command valid only with Fibre Channel storage arrays.
This command returns the progress of data synchronization between the primary virtual disk and the secondary virtual
disk in a Remote Replication configuration. This command shows the progress as a percentage of data synchronization
that has been completed.
Syntax
show remoteReplication (localVirtualDisk
["virtualDiskName"] |
localVirtualDisks ["virtualDiskName1" ...
"virtualDiskNameN"])
Parameter
Parameter
localVirtualDisk or localVirtualDisks
198
Description
The name of the local virtual disk that you want for the
primary virtual disk in the remote-replicated pair. Enclose
the primary virtual disk name in double quotation marks
(" ").
The remote storage array that contains possible virtual
disks for a secondary virtual disk. If the remote storage
array name has special characters, it must be enclosed in
double quotation marks (" ").
Description
The name of the primary virtual disk of the remote
replication pair for which you want to check
synchronization progress. Enclose the primary virtual disk
name in double quotation marks (" ") inside square
brackets ([ ]).