Parameter
physicalDiskChannel
physicalDiskChannels
allPhysicalDiskChannels
Show Physical Disk Download Progress
This command returns the status of firmware downloads for the physical disks targeted by the download
physicalDisk firmware or download storageArray physicalDiskFirmware commands.
Syntax
show allPhysicalDisks downloadProgress
Parameters
None.
NOTE: When all firmware downloads have successfully completed, this command returns a Successful status.
If any firmware downloads fail, this command shows the firmware download status of each targeted physical disk.
This command returns the status values shown in the following table.
Status
Successful
Not Attempted
Partial Download
Failed
Show RAID Controller Module
For each RAID controller module in a storage array, this command returns the following information:
•
Status (Online, Offline)
•
Current firmware and NVSRAM configuration
•
Pending firmware and NVSRAM configuration configurations (if any)
•
Board ID
•
Product ID
•
Product revision
•
Serial number
•
Date of manufacture
•
Date and time to which the RAID controller module is set
•
Associated virtual disks (including preferred owner)
196
Description
Identifier number of the physical disk port for which to
display information. Valid physical disk port values are 1
or 2. You must put brackets ([ ]) around the physical disk
channel values.
Identifier number of the physical disk ports for which to
display information. Valid physical disk port values are 1
or 2. You must put brackets ([ ]) around the physical disk
channel values.
The identifier that selects all of the physical disk ports.
Definition
Downloads completed without errors.
Downloads did not start.
Downloads are in progress.
Downloads completed with errors.