Parameter
diskGroup
Revive Disk Pool
This command forces a disk pool and its associated physical disks to the Optimal state.
CAUTION: Correct use of this command depends on the data configuration on all of the physical disks in the disk
pool. Do not try to revive a disk pool unless you are supervised by your Technical Support representative.
Syntax
revive diskPool [diskPoolName]
Parameter
Parameter
diskPool
Revive Physical Disk
This command forces the specified physical disk to the optimal state.
CAUTION: Correct use of this command depends on the data configuration on all physical disks in the disk group.
Never attempt to revive a physical disk unless supervised by a Technical Support representative.
Syntax
revive physicalDisk [enclosureID,slotID]
Parameter
Parameter
physicalDisk
Save Enclosure Log Data
This command saves the enclosure log sense data to a file. Log sense data is maintained by the environmental cards for
each enclosure. Not all of the environmental cards contain log sense data.
Syntax
save allEnclosures logFile="filename"
Parameter
Description
Number of the disk group to be set to the optimal state.
You must put brackets ([ ]) around the disk group number.
Description
The alphanumeric identifier (including - and _) of the disk
pool that you want to revive. Enclose the
square brackets ([ ]).
Description
Identifies the enclosure and slot where, the physical disk
resides. Enclosure ID values are 0 to 99. Slot ID values
are 0 to 31. You must put brackets ([ ]) around the
enclosure ID value and the slot ID value.
diskPoolName in
157