Set Snapshot Virtual Disk - Dell PowerVault MD3260 Cli Manual

Additional Information
When you use this command, you can specify one or more of the optional parameters.
Passwords are stored on each storage array in a management domain. If a password was not previously set, you do not
need a password. The password can be any combination of alphanumeric characters with a maximum of 30 characters.
(You can define a storage array password by using the set storageArray command.)
The polling interval and the number of iterations that you specify remain in effect until you end the session. After you end
the session, the polling interval and the number of iterations return to their default values.

Set Snapshot Virtual Disk

This command defines the properties for a snapshot virtual disk and lets you rename a snapshot virtual disk.
Syntax
set (virtualDisk [virtualDiskName] |
virtualDisks [virtualDiskName1 ...
virtualDiskNameN])
userLabel="snapshotVirtualDiskName"
warningThresholdPercent=percentValue
repositoryFullPolicy=(failSourceWrites |
failSnapshot)
enableSchedule=(TRUE | FALSE) |
schedule=(immediate | snapshotSchedule)
rollbackPriority=(0 | 1 | 2 | 3 | 4)
Parameters
Parameter
virtualDisk or virtualDisks
userLabel
warningThresholdPercent
repositoryFullPolicy
enableSchedule
180
Description
The name of the specific snapshot virtual disk for which
you want to define properties. (You can enter more than
one virtual disk name if you use the virtualDisks
parameter). Enclose the snapshot virtual disk name in
double quotation marks (" ") inside of square brackets ([ ]).
A new name that you want to give to a snapshot virtual
disk. Enclose the new snapshot virtual disk name in
double quotation marks (" ").
The percentage of repository capacity at which you
receive a warning that the snapshot repository is nearing
full. Use integer values. For example, a value of 70 means
70 percent. The default value is 50.
How you want snapshot processing to continue if the
snapshot repository virtual disk is full. You can choose to
fail writes to the source virtual disk
(failSourceWrites) or fail writes to the snapshot
virtual disk (failSnapshot). The default value is
failSnapshot.
Turns on or off the snapshot scheduling feature. To turn
on snapshot scheduling, set this parameter to TRUE. To
turn off snapshot scheduling, set this parameter to
FALSE.