Show Current Iscsi Sessions - Dell PowerVault MD3260 Cli Manual

Syntax
set virtualDiskCopy target [targetName] [source
[sourceName]]
copyPriority=(highest | high | medium | low | lowest)
targetReadOnlyEnabled=(TRUE | FALSE)
copyType=(online | offline)
Parameters
Parameter
target
source
copyPriority
targetReadOnlyEnabled
copyType
NOTE: When using this command, you can specify one or more of the parameters. You do not, however, need to
use all of the parameters.

Show Current iSCSI Sessions

This command displays information about an iSCSI session for either an iSCSI initiator or iSCSI target.
Syntax
When running from the command line, use:
show iscsiInitiator [\"initiatorName\"] iscsiSessions
show iscsiTarget [\"targetName\"] iscsiSessions
When running from a script file, use:
show iscsiInitiator ["initiatorName"] iscsiSessions
show iscsiTarget ["targetName"] iscsiSessions
Parameters
Description
Specifies the name of the target virtual disk for which to
define properties. You must put brackets ([ ]) around the
target virtual disk name. If the target virtual disk name has
special characters, you must also put quotation marks (" ")
around the target virtual disk name.
Specifies the name of the source virtual disk for which to
define properties. You must put brackets ([ ]) around the
source virtual disk name. If the source virtual disk name
has special characters, you must also put quotation marks
(" ") around the source virtual disk name.
Specifies the priority that the virtual disk copy has relative
to host I/O activity. Valid entries are highest, high,
medium, low, or lowest.
Specifies whether the target virtual disk is write enabled
or read only. To be able to write to the target virtual disk,
set to FALSE. To prevent writing to the target virtual disk,
set to TRUE.
Identifies a virtual disk copy with a snapshot. If the virtual
disk copy has a snapshot, set this parameter to online.
If the virtual disk copy does not have a snapshot, set this
parameter to offline.
191