Create Iscsi Initiator - Dell PowerVault MD3260 Cli Manual

host="hostName"
interfaceType=SAS
Parameters
Parameter
identifier
userLabel
host
interfaceType
NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names.
Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >) to overcome this limitation.

Create iSCSI Initiator

This command creates a new iSCSI initiator object.
Syntax
create iscsiInitiator iscsiName = "iSCSI-ID"
userLabel = "name"
host = "host-name"
[chapSecret = securityKey]
Parameters
Parameter
iscsiName
userLabel
host
chapSecret
112
Description
WWID of the HBA host port. You must put quotation marks
(" ") around the WWID.
Name to give the new HBA host port. You must put
quotation marks (" ") around the port label.
Name of the host for which you are defining an HBA host
port. You must put quotation marks (" ") around the host
name.
NOTE: An HBA host port is a physical connection on a
host adapter that resides within a host system. An
HBA host port provides host access to the virtual
disks in a storage array. If the host bus adapter has
only one physical connection (one host port), the
terms host port and host bus adapter are
synonymous.
The identifier for the type of interface for the host port.
You must enter SAS. If you do not enter SAS, the
command attempts to use an invalid type of interface. A
SAS selection requires an 8-byte WWID.
Description
The default identifier of the iSCSI initiator.
The name that you want to use for the iSCSI initiator. Enclose the name in
double quotation marks (" ").
The name of the host in which the iSCSI initiator is installed.
The password that you want to use to authenticate a peer connection.