Create Remote Replication - Dell PowerVault MD3260 Cli Manual

Parameter
mapping
warningThreshold
repositoryExpansionPolicy
cacheReadPrefetch
segmentSize
usageHint

Create Remote Replication

NOTE: This command is valid only with Fibre Channel storage arrays.
This command creates both the primary virtual disk and the secondary virtual disk for a remote replication pair. This
command also sets the write mode (Synchronous or Asynchronous) and the synchronization priority.
Syntax
create remoteReplication primary=
"primaryVirtualDiskName"
secondary="secondaryVirtualDiskName"
(remoteStorageArrayName="storageArrayName" |
remoteStorageArrayWwn="wwID")
[remotePassword="password"
syncPriority=(highest | high | medium | low |
lowest)
autoResync=(enabled | disabled)
writeOrder=(preserved | notPreserved)
writeMode=(synchronous | asynchronous)]
Parameters
120
Description
the RAID controller module firmware determines the
owner.
This parameter enables you to map the virtual disk to a
host. If you want to map later, set this parameter to none.
If you want to map the virtual disk now, set this parameter
to default, and the virtual disk is mapped to all hosts
that have access to the storage pool.
The default option is none.
Valid values are from 1 to 100.
The default value is determined by the RAID controller
module firmware.
Setting this parameter to 100 disables warning alerts.
Valid values are automatic and manual.
The setting to turn on or turn off cache read prefetch. To
turn off cache read prefetch, set this parameter to
FALSE. To turn on cache read prefetch, set this
parameter to TRUE.
Amount of data (in kilobytes) that the RAID controller
module writes on a single physical disk in a virtual disk
before writing data on the next physical disk. Valid values
are 8, 16, 32, 64, 128, 256, or 512. For information
about the segmentSize parameter, see Using the Auto
Configure Command.
Valid values are multiMedia, database or
fileSystem.