Re-Create Remote Replication Repository Virtual Disk - Dell PowerVault MD3260 Cli Manual

NOTE: Removing the drive letter of the associated virtual disk(s) in Windows or unmounting the virtual drive in
Linux helps to guarantee a stable copy of the drive for the virtual copy.
Syntax
recopy virtualDiskCopy target [targetName]
[source [sourceName]]
[copyPriority=(highest | high | medium | low | lowest)
targetReadOnlyEnabled=(TRUE | FALSE)]
copyType=(online | offline)
Parameters
Parameter
target
source
copyPriority
targetReadOnlyEnabled
copyType

Re-Create Remote Replication Repository Virtual Disk

NOTE: This command is valid only with Fibre Channel storage arrays.
146
Description
Name of the target virtual disk for which to reinitiate a
virtual disk copy operation. You must put brackets ([ ])
around the target virtual disk name. If the target virtual
disk name has special characters, you must also put
quotation marks (" ") around the target virtual disk name.
Name of the source virtual disk for which to reinitiate a
virtual disk copy operation. You must put brackets ([ ])
around the source virtual disk name. If the source virtual
disk name has special characters, you must also put
quotation marks (" ") around the source virtual disk name.
Specifies the priority that the virtual disk copy has relative
to host I/O activity. Valid entries are highest, high,
medium, low, or lowest.
NOTE: CopyPriority defines the amount of
system resources used to copy the data between the
source and target virtual disks of a virtual disk copy
pair. If you select the highest priority level, the virtual
disk copy uses the most system resources to perform
virtual disk copy, which decreases performance for
host data transfers.
Specifies whether the target virtual disk is write enabled
or read only. To be able to write to the target virtual disk,
set this parameter to FALSE. To prevent writing to the
target virtual disk, set this parameter to TRUE.
Creates a virtual disk copy with or a snapshot which
enables you to continue to write to the source virtual disk
while creating the virtual disk copy. To reinitiate a virtual
disk copy with a snapshot, set this parameter to online.
To reinitiate a virtual disk copy without a snapshot, set this
parameter to offline.