Start Disk Group Blink; Start Disk Group Defragment; Start Disk Group Export - Dell PowerVault MD3260 Cli Manual

To stop the database configuration diagnostic test, use the stop storageArray configDbDiagnostic
command.
In addition, the database configuration diagnostic test can be started using the storage management software GUI but
cannot be stopped using the storage management software GUI. If you want to stop a running diagnostic test, you must
use the stop storageArray configDbDiagnostic command.

Start Disk Group Blink

This command identifies the physical disks that are logically grouped together to form the specified disk group by
blinking the indicator LEDs on the physical disks. (Use the stop diskGroup blink command to turn off the
indicator LEDs on the physical disks.)
Syntax
start diskGroup [diskGroupNumber] blink
Parameter
Parameter
diskGroup

Start Disk Group Defragment

This command starts a defragment operation on the specified disk group.
NOTE: Defragmenting a disk group starts a long‑running operation that you cannot stop.
Syntax
start diskGroup [diskGroupNumber] defragment
Parameter
Parameter
diskGroup

Start Disk Group Export

This command moves a disk group into an Exported state. Then you can remove the physical disks that comprise the
disk group and reinstall the physical disks in a different storage array.
NOTE: Within the disk group, you cannot move virtual disks that are associated with the premium features from one
storage array to another storage array.
Syntax
start diskGroup [diskGroupName] export
Parameter
Parameter
diskGroup
208
Description
Number of the disk group to identify. You must put
brackets ([ ]) around the disk group number.
Description
Number of the disk group to defragment. You must put
brackets ([ ]) around the disk group number.
Description
Number of the disk group to defragment. You must put
brackets ([ ]) around the disk group number.