Resume Snapshot Rollback; Revive Disk Group - Dell PowerVault MD3260 Cli Manual

Parameter
writeConsistency
NOTE: If you set the writeConsistency parameter to TRUE, the virtual disks must be in a write-consistency
group (or groups). This command resumes all write-consistency groups that contain the virtual disks. For example,
if virtual disks A, B, and C are in a write-consistency group and they have remote counterparts A', B', and C', the
resume remoteReplication virtual disk ["A"] writeConsistency=TRUE command
resumes A-A', B-B', and C-C'.

Resume Snapshot Rollback

This command resumes a rollback operation that has entered a paused state. A rollback operation can enter a paused
state due to processing errors which triggers a Needs Attention condition for the storage array. If the rollback operation
cannot be resumed, the selected snapshot virtual disk reverts to a paused state, and the Needs Attention condition is
displayed.
Syntax
resume rollback virtualDisk [snapshotVirtualDiskName]
Parameter
Parameter
virtualDisk

Revive Disk Group

This command forces the specified disk group and associated failed physical disks to the Optimal state. All physical
disks assigned to the disk group must be installed before you attempt to run this command.
CAUTION: Correct use of this command depends on the data configuration on all of the physical disks in the disk
group. Never attempt to revive a physical disk unless supervised by a Customer or Technical Support
representative.
Syntax
revive diskGroup [diskGroupNumber]
Parameter
156
Description
name must also be enclosed in double quotation marks
(" ").
The setting to identify the virtual disks in this command
that are in a write-consistency group or are separate. For
the virtual disks to be in the same write-consistency
group, set this parameter to TRUE. For the virtual disks to
be separate, set this parameter to FALSE.
Description
Specifies the name of the snapshot virtual disk for which
you want to resume a rollback operation. Enclose the
snapshot virtual disk name in square brackets ([ ]). If the
snapshot virtual disk name has special characters, you
must also enclose the snapshot virtual disk name in
double quotation marks (" ").