Parameter
logFile
Save Physical Disk Channel Fault Isolation Diagnostic Status
This command saves the physical disk channel fault isolation diagnostic data that is returned from the start
physical disk channel fault isolation diagnostics command. You can save the diagnostic data
to a file as standard text or as XML.
See Start Physical Disk Channel Fault Isolation Diagnostics for more information.
Syntax
save physicalDiskChannel [(1 | 2 )]
faultDiagnostics file="filename"
Parameters
Parameter
physicalDiskChannel
file
NOTE: A file extension is not automatically appended to the saved file. You must specify the applicable format
suffix for the file. If you specify a file extension of .txt, then the output is in a text file format. If you specify a file
extension of .xml, then the output is in an XML file format.
Save Physical Disk Log
This command saves the log sense data to a file. Log sense data is maintained by the storage array for each physical
disk.
Syntax
save allPhysicalDisks logFile="filename"
Parameter
Parameter
logFile
Save RAID Controller Module NVSRAM
This command saves a copy of the RAID controller module NVSRAM values to a file. This command saves all regions.
Syntax
save controller [(0 | 1)] NVSRAM file="filename"
158
Description
Name of the file to which to save the log sense data. You
must put quotation marks (" ") around the file name.
Description
The identifier number of the physical disk channel for
which you want to save the diagnostics data. Valid values
for the identifier number are 1 or 2. Enclose the identifier
number in square brackets ([ ]).
The name of the file in which you are storing the results of
the fault isolation diagnostics test on the drive channel.
Enclose the name in double quotation marks (" ").
Description
Name of the file to which to write the log sense data. You
must put quotation marks (" ") around the file name.