Repair Virtual Disk Consistency; Replace Physical Disk - Dell PowerVault MD3260 Cli Manual

Parameter
accessVirtualDisk
host
hostGroup
NOTE: You must use the host and hostGroup parameters when specifying a nonaccess virtual disk or an
access virtual disk. The script engine ignores the host or hostGroup parameters when you use the
allVirtualDisks or virtualDisks parameters.

Repair Virtual Disk Consistency

This command repairs the consistency errors on a virtual disk.
Syntax
repair virtualDisk [virtualDiskName] consistency
consistencyErrorFile="filename"
[verbose=(TRUE | FALSE)]
Parameters
Parameter
virtualDisk
consistencyErrorFile
verbose

Replace Physical Disk

This command redefines the composition of a disk group by replacing a physical disk that is in the disk group with either:
152
Description
Removes the access virtual disk.
CAUTION: The host agent uses the access virtual
disks to communicate in-band with a storage array. If
you remove an access virtual disk mapping for a
storage array from a host that has an agent running
on it, the storage management software is no longer
able to manage the storage array through the in-band
agent.
Name of the host to which the virtual disk is mapped. You
must put quotation marks (" ") around the host name.
Name of the host group that contains the host to which
the virtual disk is mapped. You must put quotation marks ("
") around the host group name.
Description
Name of the specific virtual disk for which to repair
consistency. You must put brackets ([ ]) around the virtual
disk name. If the virtual disk name has special characters,
you must also put quotation marks (" ") around the virtual
disk name.
Name of the file that contains the consistency error
information you use to repair the errors. You must put
quotation marks (" ") around the file name.
Captures progress details, such as percent complete, and
shows the progress detail information as virtual disk
consistency is being repaired. To capture progress
details, set this parameter to TRUE. To prevent capturing
progress details, set this parameter to FALSE.