NOTE: Use the start physicalDiskChannel faultDiagnostics command and the save
physicalDiskChannel faultDiagnostics command with the stop physicalDiskChannel
faultDiagnostics command. These commands are needed to start the diagnostic test and save diagnostic
test results to a file. You can also stop the start physicalDiskChannel faultDiagnostics
command at any time by pressing <Ctrl><C>.
Stop Snapshot
This command stops a copy-on-write operation.
Syntax
stop snapshot (virtualDisk [virtualDiskName] |
virtualDisks [virtualDiskName1... virtualDiskNameN])
Parameter
Parameter
virtualDisk or virtualDisks
Stop Storage Array Blink
This command turns off the indicator lights on the storage array that were turned on by the start storageArray
blink command.
Syntax
stop storageArray blink
Parameters
None.
Stop Storage Array iSCSI Session
This command forces the termination of an iSCSI session
Syntax
stop storageArray iscsiSession [sessionNumber]
Parameter
Parameter
sessioNumber
Stop Storage Array Physical Disk Firmware Download
This command stops a firmware download to the physical disks in a storage array that was started with the download
storageArray physicalDiskFirmware command. This command does not stop a firmware download that is
Description
Name of the virtual disk for which to start the formatting.
You must put brackets ([ ]) around the virtual disk name. If
the virtual disk name has special characters, you must
also put quotation marks (" ") around the virtual disk name.
Description
The identifier number of the iSCSI session. Enclose the
identifier number of the iSCSI session in square brackets
([ ]).
217