Appendix A Jumper Settings - Mita DP-2800 Instruction Handbook Manual

The print server will normally automatically configure the network configuration
without the need to access internal jumpers. However, there are certain jumpers on the
board that you may have to access under certain circumstances. If you need to change
the jumpers, follow the steps in this section.
The EcoLAN 1000E is normally contained within the printer which acts to protect
sensitive components from damage due to electrostatic discharge (ESD) during
normal operation. When performing installation procedures, however, take proper
static control precautions to prevent damage to equipment.
Make sure you do not have the printer plugged into a wall outlet. If it is, unplug the
power cord BEFORE you open the unit. Remove the EcoLAN 1000E according to the
printer instructions.
HANDLING PRECAUTIONS
FOR
STATIC SENSITIVE DEVICES
Appendix A
Jumper Settings
Jumper Settings Appendix A- 1