Setting Up An As/400 Systems To Use Lpd; Setting Up A Dec Ultrix 4.3 Risc Or Osf1/Alpha Remote Printer - Mita DP-2800 Instruction Handbook Manual

7. At the bottom of the screen, select Remote Printer is on BSD system from the
three choices available.
8. Click on the OK button.
9. Ping the unit to test communications. Type:
ping
10. Ping should confirm your IP address with the message:
<EcoLAN 1000E IP address> is alive
11. If the connection is confirmed, you can now print.

7.3.2.5 Setting Up an AS/400 Systems to Use lpd

When working with the output queue description (WORKOUTQD), there are several
fields that must be defined for the EcoLAN 1000E to function properly as a remote
printer device. Use the following procedures to do this:
1. When prompted for the remote system, type INTNETADR so the AS/400
recognizes the device as an IP device.
2. Type PORT1.
3. Connection type must be IP.
4. Internet address must be the IP address of the EcoLAN 1000E device.
5. Destination type must be OTHER.
6. When prompted for transforming SCS to ASCII, type YES to allow the AS/400
do the character translation.
7. Manufacturer type and model must be the print driver that goes with your printer.

7.3.2.6Setting Up a DEC ULTRIX 4.3 RISC or OSF1/ALPHA Remote Printer

Set up a remote printer on the host that sends jobs to a EcoLAN 1000E.
1. At the prompt, type:
lprsetup
2. Select add.
3. Enter a name for your printer and press ENTER.
TCP/IP Configuration 7-24
<EcoLAN 1000E IP address>