Running Telnet; Making Connection And Main Menu - Mita DP-2800 Instruction Handbook Manual

7.4 Running Telnet

The Telnet utility uses the standard remote terminal protocol to configure the IP
address, lpd printers, and other parameters on your system. Use the following
guidelines to run Telnet. You have the same functionality with the HTML pages
accessed by MAP or a Web Browser, as described ion Chapter 3.
• Most often, you make selections from menus by toggling between one choice or
another, by selecting/deselecting or enabling/disabling an item.
• Press Enter, when not selecting an item. This will return you to a previous menu.
• If you do not make a menu selection for 2 minutes, you get a "Two Minute
Warning" that within 2 more minutes your Telnet session will end. This ensures
that one user does not leave a session idle for too long.

7.4.1 Making Connection and Main Menu

1. At the prompt, type:
telnet
2. When login: appears, type guest if you are only interested in browsing the menus
or sysadm if you want to change the configuration. Press ENTER. When pass-
word: appears, again type guest or sysadm and press ENTER.
3. The main menu is displayed. This utility lets you change the IP Parameters, lpd
printers, protocols, restore to factory defaults, and change password. Press the
number for the parameter you wish to check or change and press ENTER.
TCP/IP Configuration 7-40
<network interface card IP address>
The Configuration Utility
Unit Serial no. 221963 V4.10
Main Menu
1. IP Parameters
2. LPD Printers
3. Protocols
4. Restore Factory Defaults
5. Change Password
E. Exit