Windows 95; Microsoft Windows - Mita DP-2800 Instruction Handbook Manual

7.1.2 Microsoft Windows 95

Windows 95 comes with a TCP/IP stack. To print with this protocol, a client also
requires an lpr utility. This program is available from various sources. The lpr queue
can be created on each workstation or the lpr queue can be created on one workstation
and shared on the network. Windows 95 workstations can also share a lpr printer
installed on an Windows NT server on the network.
The following instructions are based on the a shareware lpr application that is
available from various sources, including Mita. You will need the wlprs41.zip and
wlprspl.txt for the lpr.
If you wish to use the Bootp Lite program, you will also need the ntBOOTP.exe file
provided with this EcoLAN 1000E on the Windows Setup Utilities diskette.
7.1.2.1 Setting up the EcoLAN 1000E with Windows 95
The EcoLAN 1000E must be given IP address and routing information to be used with
TCP/IP. This can be done with MAP if you have a NetWare connection on your
network, or with the AppleTalk KyoManage program if there is an Apple Macintosh
on the network. The KyoManage program is not included with the EcoLAN 1000E but
is available from Mita's web site at www.Mita.com/printers. Follow the instructions
for these programs which are documented elsewhere. If you cannot use these
programs, you can use either the ARP procedure, or the ntBOOTP program.
1. Install the EcoLAN 1000E in your printer.
2. Power-up the printer.
Keep the status sheet handy for the Ethernet (MAC) address. It should show that
TCP/IP is enabled but that the Protocol address is not configured.
If the unit already has an IP address, these procedures will not work. However, you
can Telnet or the HTML pages accessed by MAP or Web Browser to change the IP
parameters.
7.1.2.2 Assigning IP Address with ARP
The EcoLAN 1000E must be on the same network segment as the workstation that
you are using to configure it. The TCP/IP stack must be installed and operating.
TCP/IP Configuration 7-6