Setting Up A Sco Unix Remote Printer To Use Lpd - Mita DP-2800 Instruction Handbook Manual

4. "Do you want more information on specific printer types? " Press ENTER.
5. A list of ULTRIX-supported printers is listed. Type remote and press ENTER.
6. Enter a printer synonym (alias) and press ENTER.
7. Designate a spooler directory and press ENTER, or accept the default spooler
directory displayed and press ENTER.
8. Designate a remote system name and press ENTER.
9. Designate PORT1 as the remote system printer name and press ENTER.
10. You are asked to enter the name of a printcap symbol from a displayed list. Type
Q and press ENTER.
11. Your configuration is displayed. You are asked whether these values are final.
Type Y or N and press ENTER. An example is shown below.
Printer #7 Symbol
lp (line printer)
rm (remote host)
rp (remote printer)
sd (spooler directory)
12. Add comments to the printcap file. For example, you can type:
Dick's printer down the hall ENTER
13. Select exit to save your configuration and press ENTER.
You are now prepared to print.

7.3.2.7Setting Up a SCO UNIX Remote Printer to Use lpd

Set up a remote printer on the host that sends jobs to a EcoLAN 1000E using lpd. Use
the following procedures to do this:
1. At the prompt, type: mkdev rlp
Type Representative Value
STR
STR EcoLAN 1000E
STR PORT1
STR /usr/spool/lpd7
_host
TCP/IP Configuration 7-25