Setting Up Ip And Lpr Parameters; Setting Up Lpr On The Workstation - Mita DP-2800 Instruction Handbook Manual

5. Wait about five minutes. The EcoLAN 1000E should recycle and produce a status
sheet showing the IP parameters you have just entered.
6. Pull down Admin menu to Verify. You should get a message back stating that the
Unit is Active. If you do not get this message, verify that TCP/IP is enabled on the
status sheet.
7. When you get a response that your unit is active, you should be able to ping and
Telnet to the EcoLAN 1000E.

7.1.2.4 Setting up IP and lpr Parameters

The EcoLAN 1000E provides for a setup connection via the standard Telnet port. To
be able to make changes to a unit at factory default settings, you must logon as
sysadm. The default password is also "sysadm". (This password can be changed from
the Telnet utility.) See 7.4 Running Telnet on page 40 for instructions on using Telnet.
1. Telnet to the EcoLAN 1000E (the login and password are both "sysadm").
2. Turn off the protocols that you are not utilizing (option 3).
3. Setup the subnet mask and default gateway for the EcoLAN 1000E if applicable
(option 1).
4. Exit, Save, and Reset the EcoLAN 1000E.
You can also use the HTML pages accessible via MAP or a Web Browser to set up lpr.
The password to change parameters with the HTML pages is the same as the Telnet
password.

7.1.2.5 Setting up lpr on the Workstation

Once you install the spooler onto the workstation; the setup program will create a
group and icon.
1. Double click on the spooler icon.
2. Click on setup, define new queue.
3. At the Remote Host Name prompt enter the EcoLAN 1000E's IP Address, and for
the Remote Printer Name enter PORT1.
4. Go to Settings.
5. Select Printers.
6. Choose Add Printer.
7. Click on Next.
8. Select your driver and click on Next.
At this point, you should see an entry for your Windows lpr Spooler's printer in the
"Available Ports" listing. For example, C:\SPOOL\PRINTER_NAME.
TCP/IP Configuration 7-8