Chapter 4 Netware Configuration; Configuring Netware 2.15 And 3.1X - Mita DP-2800 Instruction Handbook Manual

Use this chapter if you will be printing from a Novell NetWare NOS. This chapter is
divided into the following sections:
• Configuring NetWare 2.15 and 3.1x describes how to configure the EcoLAN
1000E for use with Versions 2.15 or 3.1x. Use PCONSOLE to set up the print
server function.
• Configuring NetWare 4.x in Bindery Emulation describes how to configure the
EcoLAN 1000E for use with Version 4.x — Bindery Services. Use PCONSOLE to
set up the print server function.
• Configuring NetWare Directory Services describes how to configure the
EcoLAN 1000E for use with Version 4.x Directory Services. Use NWADMIN to set
up the print server function.
• EcoLAN 1000E Setup Parameters describes the parameters accessible via MAP
or an IP Browser used to configure the EcoLAN 1000E for NetWare.
• Using NetWare Utilities explains how to use standard Novell NetWare utilities to
make changes to the configuration of the EcoLAN 1000E function.

4.1 Configuring NetWare 2.15 and 3.1x

Before configuring NetWare, you must determine if the EcoLAN 1000E has its
desired name. If you change the name, use MAP or an IP Browser to change the name.
The following steps are the general procedure for configuring the EcoLAN 1000E.
You must have supervisor privileges to do this configuration. These steps are covered
in detail in the following paragraphs:
1. Start PCONSOLE and select the file server you want to use.
2. Create the print queues.
3. Specify the <EcoLAN 1000E> as a print server.
4. Configure the EcoLAN 1000E and printer.
NetWare Configuration
4
NetWare Configuration 4-1