Installing And Printing On The Hp/Ux System - Mita DP-2800 Instruction Handbook Manual

3. What is the printer name?
Type the desired printer name and press ENTER.
4. Your screen will now display the information you provided to the install script.
For example:
Node name of the EcoLAN 1000E: printfast
Printer name to be used:<printer_name>
The printer is attached on:PORT 1
You are asked to OK this configuration. Type yes or no
and press ENTER.
5. Is this printer PostScript?
Type yes or no and press ENTER.
6. The script creates a printcap entry for the printer just configured. The screen dis-
plays the entry and asks if you want the script to append it to your /etc/printcap
file. See below for a sample printcap file. Type yes or no and press ENTER. If
you type no, you may perform manual edits.
<printer_name> | EcoLAN 1000E printer:\
:lp=/dev/<printer_name>:\
:if=/usr/nic/infilter:\
:sd=/usr/spool/<printer_name>:
7. Installation for the system is done. The program prompts you to configure any
more printers. Type yes or no and press ENTER. We suggest pinging the
EcoLAN 1000E to test communications.
Like all BSD systems, ULTRIX uses the /etc/printcap file to configure a printer. The
interface to the installation script is the same for all BSD systems, however, the
printcap entry is different.
If you use the printcap entry generated automatically by the installation script, this
will be transparent to you.

7.3.3.6Installing and Printing on the HP/UX System

1. Run the Installation script by typing: nicinst.
The script automatically downloads the correct EcoLAN 1000E utilities for your particu-
lar system and prompts you for information as needed.
2. What is the node name of the Print Server unit?
Type the node name entered in /etc/hosts. For example, printfast and press ENTER.
TCP/IP Configuration 7-32