Stpc - Set Staple Counter - Kyocera DP-1800 Command Reference Manual

PRESCRIBE Command Reference
STPC —
Format
Parameter
staple-count:
Function
File
1
This value depends on the stapler to be used.
340
set STaPle Counter
STPC [staple-count or letter M (or m)];
number of sheets to be stapled at a time (When this parameter is omitted, '0' is
assumed):
1
2 to 50 = divides output pages into stacks of pages of this value and staples each of
them. The odd stack is also stapled.
M = divides output pages into stacks of pages equal to the maximum allowable number
of sheets of stapling and staples each of them. The odd stack is also stapled.
0 = same as M above but does not divide nor staple a job at all if the total number of
pages of the job is more than the maximum allowable number of sheets of stapling. The
odd stack is neither stapled.
–1 = same as 0 above but the odd stack is stapled.
The STPC command specifies the number of sheets that the stapler (finisher) staples a
job. This command does not execute stapling therefore should be used with the STPL
(staple) command.
For more simplified explanation on the staple-count, here is an example.
To print a 50-page job using a DF-31 finisher (20 pages stapler):
STPC parameter Stapling operation
M or m 20 sheets, 20 sheets, and 10 sheets are stapled.
15 15 sheets, 15 sheets, 15 sheets, and 5 sheets are stapled.
0 No stapling occurs.
–1 Only the last 10 sheets are stapled.
To staple every 5 sheets of a job at the center 2 staples, printing 15 copies of the job:
!R! STPL 3; STPC 5;
JOBS 2, 15, 1, 0, 1, "Interim Report 1", "Steve", "09/22/02
19:24";
TEXT "This is Interim Report 1 ..."; PAGE;
UNIT C; BOX 5,10; PAGE;
JOBT; EXIT;