Astk - Assign Stacker Trays; Function - Kyocera DP-1800 Command Reference Manual

PRESCRIBE Command Reference
ASTK —
Format
Parameters
tray1, tray2, tray3, ...:

Function

32
Assign STacKer trays
ASTK tray1, tray2, tray3, ...;
Number representing the tray in the optional sorter which becomes the last (bottom) tray
in each group, as counted from the top towards the bottom tray.
The ASTK command assigns the sorter trays in groups so that the sorter can be shared
among the multiple users. Each parameter represents the last tray in each group of trays.
The maximum number of parameters must be equal to the number of the trays the sorter
is equipped with. By the factory default, the trays are grouped as the following table:
Group
1
2
3
4
5
Equiv. ASTK command
The ASTK command is ignored if parameters include the value greater than the actual
number of trays. If the number of parameters is less than the maximum number of sorter
trays, the printing system automatically groups the remaining trays in one, making it the
last group. For example, the command sequence ASTK 2, 4, 6; is equivalent to ASTK 2,
4, 6, (bottom tray number);.
The tray group setting made by ASTK is stored indefinitely in the printing system's
permanent memory while the power is off, or until it is changed by another ASTK
command. It is ignored in the normal sorter mode (FRPO S0, 0;) but the printing system
automatically sets up the previous tray group setting when the sorter is again switched to
the multiple environment mode (FRPO S0, 1; or FRPO S0, 2;).
Sorter model
SO-6
1, 2
3, 4
5, 6
7, 8
9 to 15
ASTK 2, 4, 6, 8; ASTK 2, 4, 6, 8;
SO-30 SO-60
1, 2 1, 2
3, 4 3, 4
5, 6 5
7, 8 —
9 —
ASTK 2, 4;