Stpl - Staple - Kyocera DP-1800 Command Reference Manual

STPL —
STaPLe
Format
Parameter
position:
Function
STPL [position];
stapling position:
1 = bottom left, one staple
2 = top left, one staple
3 = left, two staples (straight for Legal size)
50 = top left, one staple
51 = top right, one staple
52 = left, two staples
53 = right, two staples
54 = top, two staples
Staple parameters and positions
1 2
A A A
50 51
A A A A
The STPL command staples the pages of a job at the position specified by the position
parameter (See above.) using a document finisher incorporating the stapler unit. With
position 2 (top left), stapling is automatically straightened (vertical) when Legal size
paper is used.
Parameter values 50 to 54 are valid for certain copier models only.
The number of sheets that the stapler can staple at a time depends on the STPC command
setting.
The job to be stapled must be defined by the JOBS command. Stapling is valid only
when the STPL command is issued preceding a JOBS command sequence.
The STPL command automatically deactivates Jog and Job Separation if these functions
are enabled in advance. The output stack is enforced to be the stapler output ignoring the
2, Legal 3
A A
52 53
A A
STPL
54
A
341